联系我们
Beijing Xinyuantong Environmental Engineering Technology Co., Ltd
Address:Sanxikou,Shisanling Town,Changping district,Beijing
Contactor:Mr.yao
Mobile:+86 13701372026
Tel:+8610-60775519
E-mail:xinyuantong2012@163.com
home > en > News > Technologies > Technologies
How to make stainless steel water tank insulation and more e
2015-07-13 17:06  点击数:
  How to make stainless steel water tank insulation more energy? There are pipeline and tank insulation. Pipe insulation including circulation pipe with hot water supply pipe and return pipe insulation. Pipe insulation can use two cotton or polyurethane foam insulation. Small diameter generally used cotton insulation, polyurethane foam insulation works great. At low ambient temperature, temperature drop was particularly severe, if the water supply pipes have to do backwater system and no heat supply and return pipe insulate, then the waste heat will increase, energy efficiency will be drastically reduced. Water tank insulation just as important, stainless steel water tank insulation under normal circumstances would 5mm with polyurethane foam insulation layer, then add a layer of insulation on the outside of stainless steel. Such tank insulation effect is good.
        
  On installation method will affect the heat pump energy-saving effect. Different from the method used can be divided into water and regular water supply around the clock in two modes: all-weather water is mainly used in hotels, hotels, hospitals and other places, the timing of the water is mainly used in schools, factories and other places.
       
  Regular water supply installation method is relatively simple. As long as the tank tops and the host of two pipe heating cycle to cycle, then add cold water re-used up to go after a certain period of time and re-heated. This installation method is very energy efficient. Weather water installation methods, there are many, such a useful direct thermal and circulation, the size of the tank mode and so on.
      
  Direct thermal means cold water through hot water heated directly on the host can use, the water temperature can reach between 45-55 ℃. This principle is a throttling device to control the size of fill water, the water flow can not fill the entire heat exchanger, so when the host to do direct thermal must take into account the heat exchanger tube diameter is not too large to go through repeated testing of diameter and select the most reasonable way to go water.
      
  Heating cycle by circulating heated host of water inside the water tank to heat up, when the water inside the tank part, they'll pay for the water tank and then recycled heated to the desired temperature, this installation is relatively simple .
      
  The size of the tank mode enables a host to a small water tank is heated to a certain temperature, and then the small tank of water is supplied to all large water tank, and then the small water tank heating up cold water constantly circulating, until large tank filled with hot water so far, This approach is relatively complex in control, but it does not appear that the host is basically like hydronic heating at high temperature phenomenon. Therefore, energy savings are relatively high.
  • Products
  • About
  • News
  • Join us
  • Case
  • Contact

  • Beijing Xinyuantong Environmental Engineering Technology Co., Ltd)All Right.

    ICP:京ICP备15022247号-1